QUESTION 71
You are tasked with designing a security solution for your network. What information should be gathered before you design the solution?
A. IP addressing design plans, so that the network can be appropriately segmented to mitigate potential network threats
B. a list of the customer requirements
C. detailed security device specifications
D. results from pilot network testing
Answer: B
QUESTION 72
What are three results of issuing the "switchport host" command? (Choose three.)
A. disables EtherChannel
B. enables port security
C. disables Cisco Discovery Protocol
D. enables PortFast
E. disables trunking
F. enables loopguard
Answer: ADE
QUESTION 73
Which statement about the EIGRP routing being performed by the switch is true? 
A. The EIGRP neighbor table contains 20 neighbors.
B. EIGRP is running normally and receiving IPv4 routing updates.
C. EIGRP status cannot be determined. The command show ip eigrp topology would determine the routing protocol status.
D. The switch has not established any neighbor relationships. Further network testing and troubleshooting must be performed to determine the cause of the problem.
Answer: D
QUESTION 74
What is the result of entering the command "spanning-tree loopguard default" ?
A. The command enables loop guard and root guard.
B. The command changes the status of loop guard from the default of disabled to enabled.
C. The command activates loop guard on point-to-multipoint links in the switched network.
D. The command disables EtherChannel guard.
Answer: B
QUESTION 75
Refer to the exhibit. What can be concluded about VLANs 200 and 202? 
A. VLAN 202 carries traffic from promiscuous ports to isolated, community, and other promiscuous ports in the same VLAN. VLAN 200 carries traffic between community ports and to promiscuous ports.
B. VLAN 202 carries traffic from promiscuous ports to isolated, community, and other promiscuous ports in the same VLAN. VLAN 200 carries traffic from isolated ports to a promiscuous port.
C. VLAN 200 carries traffic from promiscuous ports to isolated, community, and other promiscuous ports in the same VLAN. VLAN 202 carries traffic between community ports and to promiscuous ports.
D. VLAN 200 carries traffic from promiscuous ports to isolated, community, and other promiscuous ports in the same VLAN. VLAN 202 carries traffic from isolated ports to a promiscuous port.
Answer: B
QUESTION 76
A switch has been configured with PVLANs. With what type of PVLAN port should the default gateway be configured?
A. isolated
B. promiscuous
C. community
D. primary
E. trunk
Answer: B
QUESTION 77
Refer to the exhibit. Both routers are configured for the GLBP. Which statement is true? 
A. The default gateway addresses of both hosts should be set to the IP addresses of both routers.
B. The default gateway address of each host should be set to the virtual IP address.
C. The hosts learn the proper default gateway IP address from router A.
D. The hosts have different default gateway IP addresses and different MAC addresses for each router.
Answer: B
QUESTION 78
In the MAC address 0000.0c07.ac03, what does the "03" represent?
A. HSRP router number 3
B. Type of encapsulation
C. HSRP group number
D. VRRP group number
E. GLBP group number
Answer: C
QUESTION 79
A network is deployed using recommended practices of the enterprise campus network model, including users with desktop computers connected via IP phones. Given that all components are QoS-capable, where are the two optimal locations for trust boundaries to be configured by the network administrator? (Choose two.)
A. host
B. IP phone
C. access layer switch
D. distribution layer switch
E. core layer switch
Answer: BC
QUESTION 80
What is needed to verify that a newly implemented security solution is performing as expected?
A. a detailed physical and logical topology
B. a cost analysis of the implemented solution
C. detailed logs from the AAA and SNMP servers
D. results from audit testing of the implemented solution
Answer: D
Passleader Real Cisco 642-813 PDF & VCE Exam Dumps For Free
