web analytics

Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps (201-210)

QUESTION 201
Which trunking protocol inserts a four byte tag into the Ethernet frame and recalculates the CRC value?

A.    VTP
B.    802.1Q
C.    DTP
D.    ISL

Answer: B

QUESTION 202
What three tasks will a network administrator perform to successfully configure Hot Standby Routing Protocol (HSRP)? (Choose three.)

A.    Define the encapsulation type
B.    Define the standby router
C.    Define the standby IP address
D.    Enable the standby mode
E.    Enable HSRP

Answer: BCE

QUESTION 203
Which three protocols have been developed for IP routing redundancy to protect against first-hop router failure? (Choose three.)

A.    HSRP
B.    MSTP
C.    ICMP
D.    VRRP
E.    GLBP

Answer: ADE

QUESTION 204
Which command will ensure that External_B will be the primary router for traffic using the gateway address of 172.16.15.20?
2041

A.    On External_B add the command standby 1 priority 80.
B.    On External_A add the command standby 1 priority 110.
C.    On External_A add the command standby 1 priority 80.
D.    On External_B remove the command standby 1 preempt

Answer: C

QUESTION 205
Based on the debug output shown above, which three statements about HSRP are true? (Choose three.)
2051

A.    The final active router is 172.16.11.111.
B.    The 172.16.11.111 router has preempt configured.
C.    The 172.16.11.112 router has a more preferred priority than the 172.16.11.111 router does.
D.    172.16.1.115 is the virtual HSRP IP address.
E.    The 172.16.11.112 router has nonpreempt configured.
F.    The 172.16.11.112 router is using default HSRP priority.

Answer: ABD

QUESTION 206
Which describes the default load balancing scheme used by the Gateway Load Balancing Protocol (GLBP)?

A.    per host basis using a round-robin scheme
B.    per host basis using a strict priority scheme
C.    per session using a round-robin scheme
D.    per session using a strict priority scheme
E.    per GLBP group using a round-robin scheme
F.    per GLBP group using a strict priority scheme

Answer: A

QUESTION 207
Which First Hop Redundancy protocol cannot be configured for interface tracking?

A.    HSRP
B.    GLBP
C.    VRRP
D.    SLB
E.    RPR
F.    RPR+

Answer: C

QUESTION 208
Observe the topology in the exhibit. HSRP is configured between RTB and RTC with RTC as the active router. SW2 is configured as the root bridge for the Spanning Tree Protocol. What will happen if the serial connection on RTC is down?
2081

A.    STP will not need to be recalculated because RTB will take over as active router.
B.    RTB and RTC will flap between active and standby because the timers for STP are greater than the timers for HSRP.
C.    All traffic will automatically forward to RTB.
D.    SW3 will take over as the new root bridge.

Answer: B

QUESTION 209
Which high availability service is verified by the show standby command?

A.    VRRP
B.    GLBP
C.    HSRP
D.    MSTP
E.    PVRST

Answer: C

QUESTION 210
What is the maximum number of HSRP standby groups that can be configured on a Cisco router?

A.    16
B.    32
C.    64
D.    128
E.    256

Answer: E

Passleader Actual Cisco 642-813 PDF & VCE Exam Dumps

Welcome To Visit PassLeader